Skip to main content

Safe Use and Operation Risk Levels

Three minutes tells you which operations cut the network immediately and which ones you should not touch yourself.

Operation risk levels​

LevelOperationsConsequence
Safe to do yourselfWiring, signing in to the gateway, configuring network interfaces, enabling the networking service, platform registration, creating a network, adding devices, configuring subnet proxies, verifying connectivityA mistake only means no connectivity; change it back
Do with care (may cut the network)Switching the modem to bridge mode, changing the LAN port IP subnet, disabling DHCP, adding a static routeMay cut the network immediately; in the worst case the admin page becomes unreachable
Leave to the device supplierDevice will not power on, hardware failure, platform account problems, firmware upgrade failure, still not working after several attemptsHandling it yourself can lose the configuration or damage the device

Write it down before you change anything​

Write it down before you change anything

Before changing the modem or the LAN port, copy the original IP address, account, and mask onto paper or take a screenshot. If a mistake locks you out of the admin page, this is the only way back.

Accounts and passwords​

  • Change root / admin immediately after the first sign-in.
  • The platform account controls the whole network. Do not pass it on.
  • A forgotten gateway password can only be resolved by a factory reset, which clears the configuration. See Passwords, factory reset, and firmware upgrade.

Allow only the directions you need in access control​

The two default directions are enough: virtual network → LAN, and LAN → virtual network. Do not open everything to save effort. See Access control: which traffic to allow.

Placement and power​

  • Put the device where air flows; do not box it in a closed enclosure.
  • Use the original power adapter.
  • Avoid power loss. On a construction site or in a weak-current box, add a UPS.

Firmware upgrade​

An upgrade reboots the device and interrupts service. Do it in an idle window. For the procedure and precautions, see Passwords, factory reset, and firmware upgrade.

Reading this page once is enough

Come back to the risk table when something goes wrong; you do not need to memorize it.

Next → Choosing an access mode