Skip to main content

Bridge Mode: The Gateway Dials Up

If the optical modem is already switched to bridge mode and you have the broadband account and password, follow this page. About 10 minutes.

The most stable of the three modes

Choose bridge if the modem can be changed; it also removes the trouble of multi-layer NAT.

Step 1 — Edit the WAN port​

Open 网络(Network)→ 接口(Interfaces) and click 编辑(Edit) on the right of the WAN port.

WAN port edit button

Figure: the 编辑(Edit) button in the WAN port row.

Step 2 — Switch the protocol to PPPoE​

Select PPPoE in the protocol drop-down, then click 确认切换协议(Confirm protocol switch).

Protocol switched to PPPoE

Figure: the switch confirmation after selecting PPPoE in the protocol drop-down.

Step 3 — Enter the broadband account and password​

Enter the broadband dial-up account and password from the carrier.

PPPoE account and password

Figure: the two PPPoE fields, account and password.

Step 4 — Set the LAN port to a static IP​

Click 配置 LAN(Configure LAN) and select 静态地址(Static address). Fill in only the IP address and the subnet mask; leave everything else empty.

Configuring the LAN port

Figure: the 配置 LAN(Configure LAN) entry.

LAN port static IP

Figure: the LAN port form; only the IP address and subnet mask fields should be filled.

Fill in only the IP address and mask

Leave the gateway and DNS fields empty. Filling them in stops internet access.

Step 5 — Enable DHCP on the LAN port​

Turn on the DHCP service on the LAN port so devices below it get an address.

LAN port DHCP service

Figure: the enable switch for the LAN port DHCP service.

Step 6 — Click 应用配置(Apply configuration)​

Click 应用配置(Apply configuration) to save and wait for the page to refresh.

Apply configuration button

Figure: where the 应用配置(Apply configuration) button sits.

What you should see when done
  • The WAN port status shows connected and has an IP address
  • A computer on the LAN port can open external web pages

Next → Connecting the gateway to the platform